| set -ex |
| |
| fin=$1 |
| if [ -z "$fin" ] ; then |
| echo "need fin arg" |
| exit |
| fi |
| # fin=roi_blinky.v |
| prefix=$(echo $fin |sed "s/\.v//") |
| if [ "$fin" = "$prefix" ] ; then |
| echo "bad prefix" |
| exit |
| fi |
| echo "$fin => $prefix" |
| |
| make |
| mkdir -p $prefix |
| |
| vivado -mode batch -source /dev/stdin <<EOF |
| read_verilog $prefix.v |
| synth_design -mode out_of_context -top roi -part \$::env(XRAY_PART) |
| write_checkpoint -force $prefix.dcp |
| |
| open_checkpoint harness_routed.dcp |
| read_checkpoint -cell roi $prefix.dcp |
| opt_design |
| place_design |
| route_design |
| write_checkpoint -force ${prefix}_routed.dcp |
| write_bitstream -force ${prefix}_routed.bit |
| EOF |
| |
| make ${prefix}_routed.fasm |
| make ${prefix}_routed.hand_crafted.bit |
| |
| # Program |
| bit_fn=${prefix}_routed.hand_crafted.bit |
| openocd -f $XRAY_DIR/minitests/roi_harness/openocd-basys3.cfg -c "init; pld load 0 $bit_fn; exit" |
| |
