// Copyright 2020-2022 F4PGA Authors
//
// Licensed under the Apache License, Version 2.0 (the "License");
// you may not use this file except in compliance with the License.
// You may obtain a copy of the License at
//
//     http://www.apache.org/licenses/LICENSE-2.0
//
// Unless required by applicable law or agreed to in writing, software
// distributed under the License is distributed on an "AS IS" BASIS,
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
// See the License for the specific language governing permissions and
// limitations under the License.
//
// SPDX-License-Identifier: Apache-2.0

module conflict_out_fanout (
    input  wire        CLK,
    input  wire [ 8:0] A,
    input  wire [ 8:0] B,
    output reg  [17:0] Z,
    output wire [ 8:0] X,
);

    wire [17:0] z;
    always @(posedge CLK)
        Z <= z;

    MULT9X9 # (
        .REGINPUTA("BYPASS"),
        .REGINPUTB("BYPASS"),
        .REGOUTPUT("BYPASS")
    ) mult (
        .A (A),
        .B (B),
        .Z (z)
    );

    assign X = ~z[8:0];

endmodule

module conflict_out_fanout_to_top (
    input  wire        CLK,
    input  wire [ 8:0] A,
    input  wire [ 8:0] B,
    output reg  [17:0] Z,
    output wire [ 8:0] X,
);

    wire [17:0] z;
    always @(posedge CLK)
        Z <= z;

    MULT9X9 # (
        .REGINPUTA("BYPASS"),
        .REGINPUTB("BYPASS"),
        .REGOUTPUT("BYPASS")
    ) mult (
        .A (A),
        .B (B),
        .Z (z)
    );

    assign X = z[8:0];

endmodule

module conflict_inp_fanout (
    input  wire        CLK,
    input  wire [ 8:0] A,
    input  wire [ 8:0] B,
    output reg  [17:0] Z,
    output wire [ 3:0] X,
);

    wire [8:0] ra;
    always @(posedge CLK)
        ra <= A;

    MULT9X9 # (
        .REGINPUTA("BYPASS"),
        .REGINPUTB("BYPASS"),
        .REGOUTPUT("BYPASS")
    ) mult (
        .A (ra),
        .B (B),
        .Z (Z)
    );

    assign X = ~ra[3:0];

endmodule

module conflict_inp_fanout_to_top (
    input  wire        CLK,
    input  wire [ 8:0] A,
    input  wire [ 8:0] B,
    output reg  [17:0] Z,
    output wire [ 3:0] X,
);

    wire [8:0] ra;
    always @(posedge CLK)
        ra <= A;

    MULT9X9 # (
        .REGINPUTA("BYPASS"),
        .REGINPUTB("BYPASS"),
        .REGOUTPUT("BYPASS")
    ) mult (
        .A (ra),
        .B (B),
        .Z (Z)
    );

    assign X = ra[3:0];

endmodule