minitests/timing/basys3_demo.v

/*
 *  PicoSoC - A simple example SoC using PicoRV32
 *
 *  Copyright (C) 2017  Clifford Wolf <clifford@clifford.at>
 *
 *  Permission to use, copy, modify, and/or distribute this software for any
 *  purpose with or without fee is hereby granted, provided that the above
 *  copyright notice and this permission notice appear in all copies.
 *
 *  THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
 *  WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
 *  MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
 *  ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
 *  WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
 *  ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
 *  OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
 *
 */

module top (
	input clk,

	input di,
	input stb,
    output do
);

	wire ser_tx;
	wire ser_rx;
	wire [3:0] leds;

    assign ser_rx = di ^ stb;
    assign do = ^leds ^ ser_tx;

	reg [5:0] reset_cnt = 0;
	wire resetn = &reset_cnt;

	always @(posedge clk) begin
		reset_cnt <= reset_cnt + !resetn;
	end

	wire        iomem_valid;
	reg         iomem_ready;
	wire [3:0]  iomem_wstrb;
	wire [31:0] iomem_addr;
	wire [31:0] iomem_wdata;
	reg  [31:0] iomem_rdata;

	reg [31:0] gpio;

	assign leds = gpio[3:0];

	always @(posedge clk) begin
		if (!resetn) begin
			gpio <= 0;
		end else begin
			iomem_ready <= 0;
			if (iomem_valid && !iomem_ready && iomem_addr[31:24] == 8'h 03) begin
				iomem_ready <= 1;
				iomem_rdata <= gpio;
				if (iomem_wstrb[0]) gpio[ 7: 0] <= iomem_wdata[ 7: 0];
				if (iomem_wstrb[1]) gpio[15: 8] <= iomem_wdata[15: 8];
				if (iomem_wstrb[2]) gpio[23:16] <= iomem_wdata[23:16];
				if (iomem_wstrb[3]) gpio[31:24] <= iomem_wdata[31:24];
			end
		end
	end

	picosoc_noflash soc (
		.clk          (clk),
		.resetn       (resetn      ),

		.ser_tx       (ser_tx      ),
		.ser_rx       (ser_rx      ),

		.irq_5        (1'b0        ),
		.irq_6        (1'b0        ),
		.irq_7        (1'b0        ),

		.iomem_valid  (iomem_valid ),
		.iomem_ready  (iomem_ready ),
		.iomem_wstrb  (iomem_wstrb ),
		.iomem_addr   (iomem_addr  ),
		.iomem_wdata  (iomem_wdata ),
		.iomem_rdata  (iomem_rdata )
	);

endmodule