| // DESCRIPTION: Verilator: initial edge issue | |
| // | |
| // The module initial_edge drives the output "res" high when the reset signal, | |
| // rst, goes high. | |
| // | |
| // The module initial_edge_n drives the output "res_n" high when the reset | |
| // signal, rst_n, goes low. | |
| // | |
| // For 4-state simulators, that edge occurs when the initial value of rst_n, | |
| // X, goes to zero. However, by default for Verilator, being 2-state, the | |
| // initial value is zero, so no edge is seen. | |
| // | |
| // This is not a bug in verilator (it is bad design to rely on an edge | |
| // transition from an unitialized signal), but the problem is that there are | |
| // quite a few instances of code out there that seems to be dependent on this | |
| // behaviour to get out of reset. | |
| // | |
| // The Verilator --x-initial-edge flag causes these initial edges to trigger, | |
| // thus matching the behaviour of a 4-state simulator. This is reportedly also | |
| // the behaviour of commercial cycle accurate modelling tools as well. | |
| // | |
| // This file ONLY is placed into the Public Domain, for any use, without | |
| // warranty, 2012 by Wilson Snyder. | |
| `timescale 1ns/1ns | |
| module t (/*AUTOARG*/ | |
| // Inputs | |
| clk | |
| ); | |
| input clk; | |
| wire res; | |
| wire res_n; | |
| reg rst; | |
| reg rst_n; | |
| integer count = 0; | |
| initial_edge i_edge (.res (res), | |
| .rst (rst)); | |
| initial_edge_n i_edge_n (.res_n (res_n), | |
| .rst_n (rst_n)); | |
| // run for 3 cycles, with one cycle of reset. | |
| always @(posedge clk) begin | |
| rst <= (count == 0) ? 1 : 0; | |
| rst_n <= (count == 0) ? 0 : 1; | |
| if (count == 3) begin | |
| if ((res == 1) && (res_n == 1)) begin | |
| $write ("*-* All Finished *-*\n"); | |
| $finish; | |
| end | |
| else begin | |
| `ifdef TEST_VERBOSE | |
| $write ("FAILED: res = %b, res_n = %b\n", res, res_n); | |
| `endif | |
| $stop; | |
| end | |
| end | |
| count = count + 1; | |
| end | |
| endmodule | |
| module initial_edge_n (res_n, | |
| rst_n); | |
| output res_n; | |
| input rst_n; | |
| reg res_n = 1'b0; | |
| always @(negedge rst_n) begin | |
| if (rst_n == 1'b0) begin | |
| res_n <= 1'b1; | |
| end | |
| end | |
| endmodule // initial_edge_n | |
| module initial_edge (res, | |
| rst); | |
| output res; | |
| input rst; | |
| reg res = 1'b0; | |
| always @(posedge rst) begin | |
| if (rst == 1'b1) begin | |
| res <= 1'b1; | |
| end | |
| end | |
| endmodule // initial_edge |