| // DESCRIPTION: Verilator: Simple test of CLkDATA | |
| // | |
| // Trigger the CLKDATA detection | |
| // | |
| // This file ONLY is placed into the Public Domain, for any use, | |
| // without warranty, 2015 by Jie Xu. | |
| localparam ID_MSB = 1; | |
| module t (/*AUTOARG*/ | |
| // Inputs | |
| clk, | |
| res, | |
| res8, | |
| res16 | |
| ); | |
| input clk; | |
| output res; | |
| output [7:0] res8; | |
| output [15:0] res16; | |
| wire [7:0] clkSet; | |
| wire clk_1; | |
| wire [2:0] clk_3; | |
| wire [3:0] clk_4; | |
| wire clk_final; | |
| reg [7:0] count; | |
| assign clkSet = {8{clk}}; | |
| assign clk_4 = clkSet[7:4]; | |
| assign clk_1 = clk_4[0];; | |
| // arraysel | |
| assign clk_3 = {3{clk_1}}; | |
| assign clk_final = clk_3[0]; | |
| // the following two assignment triggers the CLKDATA warning | |
| // because on LHS there are a mix of signals both CLOCK and | |
| // DATA | |
| /* verilator lint_off CLKDATA */ | |
| assign res8 = {clk_3, 1'b0, clk_4}; | |
| assign res16 = {count, clk_3, clk_1, clk_4}; | |
| /* verilator lint_on CLKDATA */ | |
| initial | |
| count = 0; | |
| always @(posedge clk_final or negedge clk_final) begin | |
| count = count + 1; | |
| // the following assignment should trigger the CLKDATA warning | |
| // because CLOCK signal is used as DATA in sequential block | |
| /* verilator lint_off CLKDATA */ | |
| res <= clk_final; | |
| /* verilator lint_on CLKDATA */ | |
| if ( count == 8'hf) begin | |
| $write("*-* All Finished *-*\n"); | |
| $finish; | |
| end | |
| end | |
| endmodule |