| // Annulls a value (gates it to zero) | |
| // We put something this simple into a module since it conveys intent, | |
| // and avoids an RTL schematic cluttered with a bunch of AND gates. | |
| // We do this using logic instead of a register synchronous clear | |
| // since it might not be as portable, nor synthesize as well. | |
| // See http://www.altera.com/literature/hb/qts/qts_qii51007.pdf (page 14-49): | |
| // // Creating many registers with different sload and sclr signals can make | |
| // // packing the registers into LABs difficult for the Quartus II Fitter | |
| // // because the sclr and sload signals are LAB-wide signals. In addition, | |
| // // using the LAB-wide sload signal prevents the Fitter from packing | |
| // // registers using the quick feedback path in the device architecture, | |
| // // which means that some registers cannot be packed with other logic. | |
| // // Synthesis tools typically restrict use of sload and sclr signals to | |
| // // cases in which there are enough registers with common signals to allow | |
| // // good LAB packing. Using the look-up table (LUT) to implement the signals | |
| // // is always more flexible if it is available. Because different device | |
| // // families offer different numbers of control signals, inference of these | |
| // // signals is also device-specific. For example, because Stratix II devices | |
| // // have more flexibility than Stratix devices with respect to secondary | |
| // // control signals, synthesis tools might infer more sload and sclr signals | |
| // // for Stratix II devices. | |
| `default_nettype none | |
| module Annuller | |
| #( | |
| parameter WORD_WIDTH = 0 | |
| ) | |
| ( | |
| input wire annul, | |
| input wire [WORD_WIDTH-1:0] in, | |
| output reg [WORD_WIDTH-1:0] out | |
| ); | |
| initial begin | |
| out = 0; | |
| end | |
| always @(*) begin | |
| out <= (annul == 1'b1) ? {WORD_WIDTH{1'b0}} : in; | |
| end | |
| endmodule | |