| `default_nettype none | |
| // So Verilog is very sad when it comes to enumerations. The easiest way to emulate this behavior is probably to define a macro for the enumeration and then instantiate it everywhere the type is used. | |
| `define MODE_T\ | |
| parameter MODE_A = 32'b0;\ | |
| parameter MODE_B = 32'b1 | |
| `define OPERATION_T\ | |
| parameter READ = 2'd1;\ | |
| parameter WRITE = 2'd2;\ | |
| parameter NONE = 2'd0 | |
| module Example( | |
| input wire rawMode, | |
| output wire [1:0] rawOperation | |
| ); | |
| `MODE_T; | |
| `OPERATION_T; | |
| // Enumeration variables don't have types, so they need to be default wires. | |
| // Technically this could be just one bit if the tool is smart enough to realize. | |
| wire [31:0] mode; | |
| reg [1:0] operation; | |
| // No need for a cast since everything is a wire | |
| assign mode = rawMode; | |
| assign rawOperation = operation; | |
| always @* begin | |
| case(mode) | |
| MODE_A: operation = READ; | |
| MODE_B: operation = WRITE; | |
| default: operation = NONE; | |
| endcase | |
| end | |
| endmodule |