UVM/ovm-2.1.2/examples/xbus/sv/xbus_if.sv

//----------------------------------------------------------------------
//   Copyright 2007-2009 Mentor Graphics Corporation
//   Copyright 2007-2009 Cadence Design Systems, Inc.
//   All Rights Reserved Worldwide
//
//   Licensed under the Apache License, Version 2.0 (the
//   "License"); you may not use this file except in
//   compliance with the License.  You may obtain a copy of
//   the License at
//
//       http://www.apache.org/licenses/LICENSE-2.0
//
//   Unless required by applicable law or agreed to in
//   writing, software distributed under the License is
//   distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR
//   CONDITIONS OF ANY KIND, either express or implied.  See
//   the License for the specific language governing
//   permissions and limitations under the License.
//----------------------------------------------------------------------
/******************************************************************************

  FILE : xbus_bus_monitor_if.sv

 ******************************************************************************/

interface xbus_if;

  // Control flags
  bit                has_checks = 1;
  bit                has_coverage = 1;

  // Actual Signals
  logic              sig_clock;
  logic              sig_reset;
  logic       [15:0] sig_request;
  logic       [15:0] sig_grant;
  logic       [15:0] sig_addr;
  logic        [1:0] sig_size;
  logic              sig_read;
  logic              sig_write;
  logic              sig_start;
  logic              sig_bip;
  wire logic   [7:0] sig_data;
  logic        [7:0] sig_data_out;
  logic              sig_wait;
  logic              sig_error;

  logic              rw;

assign sig_data = rw ? sig_data_out : 8'bz;

// Coverage and assertions to be implemented here.

always @(negedge sig_clock)
begin

// Address must not be X or Z during Address Phase
assertAddrUnknown:assert property (
                  disable iff(!has_checks) 
                  ($onehot(sig_grant) |-> !$isunknown(sig_addr)))
                  else
                    $error("ERR_ADDR_XZ\n Address went to X or Z \
                            during Address Phase");

// Read must not be X or Z during Address Phase
assertReadUnknown:assert property ( 
                  disable iff(!has_checks) 
                  ($onehot(sig_grant) |-> !$isunknown(sig_read)))
                  else
                    $error("ERR_READ_XZ\n READ went to X or Z during \
                            Address Phase");

// Write must not be X or Z during Address Phase
assertWriteUnknown:assert property ( 
                   disable iff(!has_checks) 
                   ($onehot(sig_grant) |-> !$isunknown(sig_write)))
                   else
                     $error("ERR_WRITE_XZ\n WRITE went to X or Z during \
                             Address Phase");

// Size must not be X or Z during Address Phase
assertSizeUnknown:assert property ( 
                  disable iff(!has_checks) 
                  ($onehot(sig_grant) |-> !$isunknown(sig_size)))
                  else
                    $error("ERR_SIZE_XZ\n SIZE went to X or Z during \
                            Address Phase");


// Wait must not be X or Z during Data Phase
assertWaitUnknown:assert property ( 
                  disable iff(!has_checks) 
                  ($onehot(sig_grant) |=> !$isunknown(sig_wait)))
                  else
                    $error("ERR_WAIT_XZ\n WAIT went to X or Z during \
                            Data Phase");


// Error must not be X or Z during Data Phase
assertErrorUnknown:assert property ( 
                   disable iff(!has_checks) 
                   ($onehot(sig_grant) |=> !$isunknown(sig_error)))
                   else
                    $error("ERR_ERROR_XZ\n ERROR went to X or Z during \
                            Data Phase");


//Reset must be asserted for at least 3 clocks each time it is asserted
assertResetFor3Clocks: assert property (
                       disable iff(!has_checks) 
                       ($rose(sig_reset) |=> sig_reset[*2]))
                       else 
                         $error("ERR_SHORT_RESET_DURING_TEST\n",
                                "Reset was asserted for less than 3 clock \
                                 cycles");

// Only one grant is asserted
//assertSingleGrant: assert property (
//                   disable iff(!has_checks)
//                   (sig_start |=> $onehot0(sig_grant)))
//                   else
//                     $error("ERR_GRANT\n More that one grant asserted");

// Read and write never true at the same time
assertReadOrWrite: assert property (
                   disable iff(!has_checks) 
                   ($onehot(sig_grant) |-> !(sig_read && sig_write)))
                   else
                     $error("ERR_READ_OR_WRITE\n Read and Write true at \
                             the same time");

end

endinterface : xbus_if