tests/arch/xilinx/pmgen_xilinx_srl.ys

read_verilog -icells <<EOT
module \$__XILINX_SHREG_ (input C, input D, input [31:0] L, input E, output Q, output SO);
  parameter DEPTH = 1;
  parameter [DEPTH-1:0] INIT = 0;
  parameter CLKPOL = 1;
  parameter ENPOL = 2;

  wire pos_clk = C == CLKPOL;
  reg pos_en;
  always @(E)
    if (ENPOL == 2) pos_en = 1'b1;
    else pos_en = (E == ENPOL[0]);

  reg [DEPTH-1:0] r;
  always @(posedge pos_clk)
    if (pos_en)
      r <= {r[DEPTH-2:0], D};

  assign Q = r[L];
  assign SO = r[DEPTH-1];
endmodule
EOT
read_verilog +/xilinx/cells_sim.v
proc
design -save model

test_pmgen -generate xilinx_srl.fixed
hierarchy -top pmtest_xilinx_srl_pm_fixed
flatten; opt_clean

design -save gold
xilinx_srl -fixed
techmap -autoproc -map %model
design -stash gate

design -copy-from gold -as gold pmtest_xilinx_srl_pm_fixed
design -copy-from gate -as gate pmtest_xilinx_srl_pm_fixed
dff2dffe -unmap # sat does not support flops-with-enable yet
miter -equiv -flatten -make_assert gold gate miter
sat -set-init-zero -seq 5 -verify -prove-asserts miter

design -load model

test_pmgen -generate xilinx_srl.variable
hierarchy -top pmtest_xilinx_srl_pm_variable
flatten; opt_clean

design -save gold
xilinx_srl -variable
techmap -autoproc -map %model
design -stash gate

design -copy-from gold -as gold pmtest_xilinx_srl_pm_variable
design -copy-from gate -as gate pmtest_xilinx_srl_pm_variable
dff2dffe -unmap # sat does not support flops-with-enable yet
miter -equiv -flatten -make_assert gold gate miter
sat -set-init-zero -seq 5 -verify -prove-asserts miter